Pro 2500 Eco Control Board

Pro 2500 Eco Control Board

Up to 10 stops, simple (up and down) and full batch control
Compatible with single speed, double speed and VVVF elevators
Adjustable lock standby, floor standby, maximum high speed, maximum low speed and cabin light duration
Built-in automatic door card
Call lapm and buttons can be connected to the system with a single shared cable.
Error-free and easy installation using the integrated terminal board
Cabinet serial communication output
Positioning information with bistable switches
Adjustable parking station and arrival time at the parking stop.
After a power cut, the vehicle takes power and moves to the first stop (depending on demand)
Manual movement using low speed program buttons
function Overload warning function
Adjustable maintenance time and warning indicator on the LCD screen when maintenance is required
When the door is left open for a long time or the long-term stop return circuit is not detected, you can see the Warning function on the LCD screen on the card.
Adjustable display outputs for each station with short circuit protection
Electronic control of phases, phase sequences and PTC (motor temperature) and errors related to these controls can be seen on the LCD of the device. card. These functions can be disabled by parameter selection; phase level sensitivity adjustable
Outputs for direction arrows, out-of-service signal and busy signal with 5A relay contact; these outputs
A common signal input for elevators with only one fully automatic door, the floor with the fully automatic door can be selected.
. In revision mode, you can choose to move the lower and upper limit contacts or floor level;
Display outputs can be switched to gray code or binary code output.
All parameters can be easily adjusted via LCD screen or keyboard buttons

  • Contact us

    I have read and accept the KVKK terms.
    Contact Us

    Online Sales Departmant

    Sales Departmant

    Technical support

    Operations Department

    Accounting department

    Secretary